Parag Fans & Cooling System LTD.

The mechanically forced-draft or induced-draft cooling towers are used to remove the heat absorbed in the circulating cooling water systems. Fan is a very important component of the cooling tower.

	Available Sizes : 2 Feet to 36 Feet ( 600 mm to 10974 mm).
	Number of Blades : 4 to 12 .
	Static Pressure : Up to 1 inch of WG (25 mm).
	Air Flow : Up to 30,00,000 CFM (1420 m^3 / sec).
	Fan RPM : Up to 1440 .
	Operating Temperature Range : - 40ºC to 120ºC .

Typical Cross Flow Induced-draft Cooling Tower

PARAG High Efficiency Cooling Tower FRP Fan

Features & Benefits
FRP FAN:
	High efficiency of operation.
	More air with less power.
	Reduced power for same air.
	Optimal operational cost.
	Economical initial cost.
	Small fans up to 6 feet (1800 mm) diameter are dynamically balanced as per ISO–1940 Grade 6.3.

FRP BLADE:

	Blade aerofoil with high lift and low drag.
	Uniform air flow over entire blade length.
	Special leading edge protection.
	Corrosion and erosion resistant FRP Blades.
	UV resistant Blades
	Blades are moment balanced to ensure inter-changeability.
	Special blade shapes for standard and low noise fans.
	Convenient blade tip angle setting
	Individual moulds for each blade size to maintain high efficiency

SEAL DISK:
	One Piece Statically Balanced Seal Disks
	Optional Segmented Seal Disk for ease in handling and transportation.
	Each segment of Seal Disk is moment balanced.
	Seal Disk to prevent swirl.
	UV resistant Seal Disk


HUB:
	Easy to install hot dip galvanized double plate box type Hubs.
	Optional welded Hubs to reduce initial cost.
	Hubs are dynamically balanced to ISO – 1940 Grade 6.3
	Hubs to suit standard taper lock bushings or custom specified gear box output shafts.
	Ease in handling and maintenance.

Standard Material of Construction

Blades : Fiber Glass Reinforced Plastic using Polyester or Epoxy Resins.

Hub

• Plates	: Hot Dipped Galvanised Mild Steel.
• Fasteners	: Galvanized Steel / SS-304.
• Blade Holding blocks	: Cast Aluminum Alloy LM-6 / Cast Iron FG-200.
• Center Bush	: Cast Iron FG-200.

Seal Disk: Fiber Glass Reinforced Plastic.

Downloads:

Fan Seletion Program
Fan Data Request Form for New Equipments
Fan Data Request Form for Engineer Retrofits
Assembly & Installation Manual	794 KB	Download
General Arrangement Drawings
Operations & Maintenance Manual	314 KB	Download
Company Brochure	4.18 MB	Download
Product Brochure
Terms of Sale	154 KB	Download

* For any specific duties, applications, sizes or special materials of construction, please contact us

Unless otherwise stated, this website is for information only. PARAG has used all reasonable care and skill in compiling the content of this
website but makes no warranty as to the accuracy of any information on this website and cannot accept liability for any errors or omissions.